- 9 -
when press power button for 3 seconds to turned off, and the "drop'sounds , the power is turned off
successfully;
●
Speed limited grade:Speed limit reduction (Part 2 of the above figure), lowering the maximum
speed limit when pressed;The speed limit added (Part 3 of the above figure), and the maximum
speed limit is increased when pressed.
●
Speaker: as figure 6 above,the horn sounds when pressed, and it does not ring if loose;
2
、
Electronic Brake
This electric wheelchair uses an advanced electronic brake system to stop if let go,do not turn off
the power when going uphill and downhill conditions. If you want stop or get off the wheelchair,
first pull the brakes to ensure that the brakes can be turned off by the two rear wheels to prevent the
wheelchair from slipping automatically. Follow this operation to ensure safe use. Users are advised
to turn off the controller without using a wheelchair to reduce power consumption.
3
、
Low Battery Smart Brake
（
1
）
Wheelchair with electric and manual 2 driving modes.When it is turned on, the electric
mode is automatically activated;it is the manual mode when it is off.When the user stops, please
tighten the left and right rear brakes.
（
2
）
During the trip, if the power is less than 10%, (part 7 of above figure) ,please charge in
time. It is recommended to tighten the rear wheel brake or turn on the manual mode to seek help
from the caregiver.
（
3
）
In the case of uneven roads, it is also recommended to use the manual mode, which is
boosted by the caregiver to ensure safety.
4
、
Charging
（
1
）
You must use the special charger provided with your electric wheelchair to ensure safe use.
Plug the charger's charging output plug into the charging socket on the back of the controller;
（
2
）
The charger power plug is plugged into a voltage and frequency matching power supply;
（
3
）
When the charging indicator on the charger turns green, it indicates that the power is
sufficient,(The battery capacity is 6Ah, the charging time depends on the amount of remaining
power in the original battery, and the uncharged new battery is filled for about 4-5 hours for the first
time),unplug the charger and the charging output plug when sufficient.
（
4
）
Charging method:Insert charging head of the charger into the charging port on the bottom of
the remote control, as shown in the figure.
Charging port start of charge
Attention:
Causes of minor injuries and moderate injuries