i-B350L -CC
– Hardware User Manual | 20. September 2019
Copyright © 2019 IDENTEC SOLUTIONS. All rights reserved.
3
Radio Frequency Compliance Statement
IDENTEC SOLUTIONS is the responsible party for the compliance of the following devices:
MODEL:
i-B350L CC
Region/Country
Organization
Marking
EUROPE:
EU
CE
USA:
FCC
FCC ID: OO4-ILR-IB350LCC
CANADA:
Industry Canada
3538A-IB350LS
The user(s) of these products are cautioned to only use accessories and peripherals approved, in advance, by
IDENTEC SOLUTIONS. The use of accessories and peripherals, other than those approved by IDENTEC
SOLUTIONS, or unauthorized changes to approved products, may void the compliance of these products and result in
the loss of the user(s) authority to operate the equipment.
European Notification According R&TTE Directive
This equipment complies to Art. 6.4 of R&TTE Directive (2014/35/EU, 2014/30/EU, 99/5/EC [expires on June, 12
th
2016] and 2014/53/EU [valid from June, 13
th
2016]). It is tested for compliance with the following standards: EN 300
220-1, ETSI EN 300 220-2, ETSI EN 301 489-1, ETSI EN 301 489-3, EN 60950-1:2006 + A11:2009 + A1:2010 +
A12:2011
USA Notification
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.
CAUTION TO USERS
Changes or modifications not expressly approved by the party responsible for
compliance could void the user`s authority to operate the equipment.
Class B: (Section 15.105) FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT This
equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or
relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the
equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an
experienced radio/ TV technician for help. (Section 15.21) CAUTION: Any changes or modifications not expressly
approved by the grantee of this device could void the user's authority to operate the equipment.
Canada Certification
This device complies with Industry Canada’s license exempt RSS’s. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
Le présent appareil est conforme aux CNR d‘Industrie Canada applicables aux appareils radio exempts de licence.
L‘exploitation est autorisée aux deux conditions suivantes:
(1) l‘appareil ne doit pas produire de brouillage, et
(2) l‘utilisateur de l‘appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible
d‘en compromettre le fonctionnement.
Summary of Contents for 455361
Page 1: ...IDENTEC SOLUTIONS i B350L CC HARDWARE USER MANUAL...
Page 16: ......