IDENTEC SOLUTIONS 455361, Hardware User Manual

Page: 11 / 16

i-B350L -CC
– Hardware User Manual | 20. September 2019
Copyright © 2019 IDENTEC SOLUTIONS. All rights reserved.
11
3. Configuration of the Tag
3.1 General
The i-B350L CC is configured using the i-PROG M350L programming device.
Important Note
Do not open the housing! Configuration is done using the built-in air interface of the i-B350L CC.
In addition to the Broadcast mode the i-B350L CC offers the following special functions that can be configured:
•
Bursts on entering a marker field can be configured independent from regular Pings
•
Marker technology
•
Bursts triggered by the push button can be configured independent from regular Pings
Tools Needed
•
PC running on MS Windows with the SensorSMART Tool software
•
Connected to an i-PROG M350L to configure the tags
Overview on the Configuration Software
3.2 Ping Rate
Note: This setting can be found in the ILR Tag Configuration software tool in the edit block “Broadcast”
•
Broadcast Interval: 0 = no broadcast messages are sent, value > 0 = Broadcast interval in seconds. This
can be set in steps of 0.5 sec, from 0.5 to 300 seconds.
Select Ping Rate and Ping
Message Content in the block
“ Broadcast ”
Select Burst behavior on
entering a marker field in
the block
“Marker”