IDEC WB1F Series, User Manual

Page: 55 / 116

2. Installation & wiring Function 4. Support tool 5. Appendix 1. Overview
3-32
Setup support mode
z
Reading count mesurement
This measurement outputs and displays the count of consecutively read barcodes.
It outputs and displays the count from when a barcode was successfully read to when reading a barcode failed.
This can be used to check how stable consecutive barcode reading is when reading barcodes.
The measurement results can be checked with the communication interface and the indicator LEDs.
An example of the measurement results output format is as follows.
Times:[reading count]: ID:[AIM ID] Code:[reading results data] Length:[barcode length] CR LF
* At this time, the global prefix is fixed as "none" and the global suffix is fixed as "
CR LF
".
Example: When the reading count is "100", the AIM ID is "]E0", the reading results data is "4901234567894", and the bar-
code length is "13"
Times:100: ID:]E0 Code:4901234567894 Length:13 CR LF
The operation of the indicator LEDs is as follows.
Reading
count
0 times 1-9 times 10-19 times 20-29 times 30-39 times 40-49 times
50 times or
more
LED (green)
(G) (G) (G) (G) (G) (G) (G)
LED (orange)
(O) (O) (O) (O) (O) (O) (O)
LED (red)
(R) (R) (R) (R) (R) (R) (R)
z
At the start of the measurement, the "Waiting barcode label...
CR LF
" message is output to the commu-
nication interface.
z
To stop the measurement, push the Operation button or input the communication command suffix. (The
initial value is
CR LF
)
z
When the measurement is ended, the unit returns to the same operation mode as before you switch to set-
up support mode.
z
The maximum value of the reading count that can be measured is 100 times.