IDEC SmartRelay FL1D Series, User Manual, Page: 86 / 336

Programming IDEC SmartRelay
IDEC SmartRelay Manual
76
Let us assume you want to name your circuit program
“ ABC ”:
5. Select “ A ”: Press
▼
6. Move to the next letter: Press
7. Select “ B ”: Press ▼
8. Move to the next letter: Press
9. Select “ C ”: Press ▼
10. To confirm the complete name: Press OK
Your circuit program is now named “ ABC ”, and you are re-
turned to the programming menu.
To
change the name of your circuit program, proceed in the
same way.
Note
You can change the name of the circuit program only in program-
ming mode. You can read the name both in programming
and in
parameter assignment mode
3.6.5 Password
You can protect a circuit program from unauthorized access
by assigning it a password.
To assign a password
A password may have a maximum length of 10 characters,
and consists only of uppercase letters (A to Z). On IDEC
SmartRelay, the password can be assigned, edited or deac-
tivated only in the “Password” menu.
In the programming menu:
1. Move the “>” cursor to ' Password ': Press
▼
or
▲
2. To confirm the 'Password': Press OK
Press
▼
or
▲
to move up and down the alphabet to select
your letters. Because IDEC SmartRelay only provides up-
percase letters for the password, you can quickly access let-
ters “at the end” of the alphabet by using the
▲
button:
▲▲
Courtesy of Steven Engineering, Inc. ● 230 Ryan Way, South San Francisco, CA 94080-6370 ● General Inquiries: (800) 670-4183 ● www.stevenengineering.com