IDEC SmartAXIS FT9Z-1A01, User Manual

Page: 234 / 393

9: M
AINTENANCE
C
OMMUNICATION
9-4 S
MART
AXIS P
RO
/ L
ITE
U
SER
'
S
M
ANUAL
FT9Y-B1378
2.
In the Communication Mode pull-down list for Port 2, select Maintenance Protocol .
The Maintenance Communication (Port 2) dialog box appears.
3.
Configure the parameters to match the communication settings of the computer or operator interface.
Notes:

Values not in parentheses are the default settings.

The following configuration cannot be selected: Data Bits: 7, Parity: None
4. Click OK .
Configuring the maintenance communication for the expansion communication port is now complete.
Baud Rate (bps): 115200bps (1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200)
Data Bits: 7 (7 or 8)
Parity: Even (None, Even, Odd)
Stop Bits: 1 (1 or 2)
Receive Timeout (ms): 500 (10 to 2550)
Slave Number 0 (0 to 31)
Slave number can be specified by either a constant or a data register.
Type Details
Constant Set within the range of 0 to 31
Data register
Store the slave numbers 0 to 31 in the following special data registers
Port 2: D8027
Port 3: D8028