IDEC MICRO/I HG4G-CJT22 F-B Series, User Manual, Page: 308 / 1665

3 Project Settings Dialog Box
4-54
WindO/I-NV4 User’s Manual
3.6 User Communication Tab
The User Communication tab is used to configure communication with external devices such as barcode readers.
For details, refer to Chapter 3 “5 User Communication” on page 3-8. This option can only be configured when User
Communication 1 , User Communication 2 , or User Communication 3 is selected for Function under
Interface Settings on the Communication Interface tab.
■
(Protocol List)
Displays the registered user communication protocol.
HG3G HG2G-5F HG5G-V HG4G-V HG3G-V HG2G-V HG2G-5T HG4G HG1G HG1P
(Protocol List)
(Type)
No.: Displays the number for managing the user communication protocol.
Protocol Name: Enter the name of the user communication protocol. The maximum number for protocol name is 40
characters.
You cannot use the following characters in the protocol name.
\ /
: , ; * ? " < > |
Receiving Character Time Out (x100 msec)
Specify the time out value (0 to 255) from when 1 frame of data has been received to when the next frame of
data starts to be received. A frame refers to a data string from the beginning to the end of a command. If the
Receiving Character Time Out is set to 0, it is not monitored. These setting items are used only with receive
command.
Example: The received data (1 frame) is 2 bytes, the While ON is selected as the Trigger Type in the Trigger
Condition and LM100 is set to the Device Address , LM101 is set to the Completed Device
Address , and LDR110 is set to the Status Device Address
The data of second byte starts to be received before exceeding the Receiving Character Time Out
duration after the data of first byte is received, and the values of the Completed Device Address and
Status Device Address when receiving of the data has been successfully completed are as follows.
• The value of the Completed Device Address LM101 changes to 1.
When the Not Clear Completed Device Address automatically check box is not selected, when
the value of the Trigger Condition device address LM100 changes from 0 to 1, the value of the
Completed Device Address LM101 changes to 0.
When the
Not Clear Completed Device Address automatically check box is selected, the value
of Completed Device Address LM101 remains 1, so set 0 if necessary.
: