Chapter 2
Test Setup Procedures
3.
Press ENTER to save or ESCAPE to exit.
Note: Refer to the following conversion for differences in measurement units:
1 meter = 3.28084 ft
1 foot = 0.3048006 m
BAUD RATE
When using the RS-232 serial port, this option can configure the baud rate at which
information will be transmitted.
1.
Select Baud Rate on the Preferences screen. Press ENTER. The Baud Rate screen
appears.
Figure 2-7: Baud Rate Screen
2.
Select
or
to choose the desired setting.
3.
Press ENTER to save or ESCAPE to exit.
TALKSET
LANTEK testers are “Talkset ready.” Use this option to configure communications
between the Display Handset and the Remote Handset through an externally attached
microphone/headset.
To talk with someone using the talkset, both the Display Handset and the Remote
Handset must be connected to a cable.
If the Talkset is set to “Auto,” the Talkset feature is automatically enabled when
Autotest is not running. If the Talkset is set to “Manual,” the TALK button must be
pressed momentarily to enable the Talkset feature.
The units will remain in “Talk” mode until the ESCAPE button on either unit is
pressed, the AUTOTEST button is pressed, or after a period of no talk activity is
detected by the Display Handset.
1.
Select Talkset on the Preferences screen. Press ENTER. The Talkset screen
appears.
2.
Press the ARROW keys to highlight the desired setting.
3.
The default setting for Talkset is “Manual”. Select
or
to select the
desired setting.
2-5
www.vemco.pl
