IDEAL Bikes TARGET, Instructions For Use Manual

Page: 68 / 88

OTHER COMPONENTS
68
Opening and closing a quick-release clamp
• Open the quick-release clamp by pulling the lever outwards (away from the component
that it is resting against when closed).
• Close the quick-release clamp by pushing the lever against the corresponding compo-
nent until it is resting against it.
• The quick-release clamp should be adjusted if you notice that it is not holding the
component securely in place or if it closes too easily.
• Have your specialist dealer replace any worn or damaged quick-release clamps with
suitable original spare parts.
Adjusting a quick-release clamp
1. Open the quick-release lever.
2. Turn the tensioning screw clockwise one quarter of a revolution.
3. Close the quick-release lever.
4. Then check whether the quick-release clamp is securing the component properly.
Repeat the process until the quick-release clamp is securing the component properly
when closed.
If you cannot secure the component properly, contact your specialist dealer.
43 Bell
Depending on the model, the bicycle is fitted with a bell on delivery. If the bicycle is not fitted
with a bell, you can retrofit one.
• In case of any questions, consult your specialist dealer.
To enable you to give clearly audible acoustic signals for the benefit of other road users
while cycling, the bicycle must be fitted with an appropriate bell prior to use on public roads.
• If the bell attached to the bicycle does not make a clearly audible sound, contact your
specialist dealer to have the bell replaced.
• Position the bell on the handlebar so that you can easily reach it without taking your
hand off the handlebar grip.