Manual IB-3640 Series
17
Version 1.1
6.
R
EFERENCES
1.
Changing the RAID mode will cause data lost.
2.
Please refer to the instructions when switching the RAID mode, otherwise the execution
might fail.
3.
Interface of USB / eSATA / (Firewire)
cannot
be used at the same time.
4.
When using the RAID function, HDD’s with the same brand, model and capacity is strong
recommended.
5.
When using RAID function, more than one HDD partition is not recommended.
6.
Under Windows Vista /7, users can enable GPT when initializing HDD with a total capacity of
more than 2 TB.
7.
Older OS may not recognize the device if you use a different operation system than Windows
Vista / Windows7. For more detailed information about GTP, please visit:
If users enable MBR by mistake, in order to clean the partition table, you have to switch to
another RAID mode and do the RAID mode switch all over again referring to Setup. Then go
back to the RAID mode you want, repeat the previous actions and enable GPT when
initializing HDD.
9.
For Macintosh users: the total capacity of more than 2 TB could be recognized only for the
operation system 10.4.11 Tiger or later.
10.
Do not connect the device to the SATA on board port of the motherboard. Either use SATA to
eSATA PCI-Express or SATA to eSATA PCI add-on card; otherwise the PC (Windows /
Macintosh) may not recognize the device.
11.
In RAID 1, HDD1 and I-IDD2 must be installed; otherwise the PC (Windows / Macintosh)
cannot recognize the device.
12.
Rebuild time is based on the capacity, e.g. it takes about 1 hour for 200 GB.
13.
When the USB / eSATA cable is plugged out, the device goes to sleeping mode
automatically.
14.
To take out the HDD from the device, slightly press down the handle of the tray and pull it
out.
15.
Setting up motherboard‘s power management in S3 is recommended.
(For more details refer to the user guide of motherboard BIOS setting).
16.
If the device takes too long to initialize, please check if the HDD is securely installed or
update the SATA host driver version.
17.
If the transfer rate is not normal, please check if the setting of SATA disk jumper is 1.5 or 3.0
Gbit/s.
18.
If there is noise with the fan, power off the device, unscrew the fan, take out the cover,
clean the fan end assemble it back.
19.
If the noise is still present, you can change the fan with another identical fan of Size
80X80X20mm.
20.
If the fan stops working, do not dismantle it. Please send back to the retail store immediately.
21.
Temperature 0 ~ 60 °C
Humidity 90 RH
22.
Smart fan controlled by the built-in thermal sensor and it comes with 2 modes (auto/manual)
and 3 levels of speed:
