ICWUSA.com, Inc.
If you have any questions, please call 1-800-558-4435
LAPTOP TRAY ARM INSTALLATION
LAPTOP TRAY ARM INSTALLATION - rev 09/27/2011 mf
Locate the wall stud and mark the top
hole of the Wall Track, drill 11/64 pilot
hole and insert #14 screw and tighten
slightly. Use a level, mark the lower
holes, drill pilot holes and then insert the
#14 screws.
NOTE: #14 Wood screws are supplied with unit. If
installing into metal studs, you will need to replace
these with proper metal stud fasteners
MOUNT ULTRA TRACK TO WALL
Remove
small socket
head cap
screw in the
top middle
of the Wall
Track.
Remove
plastic cover.
Insert Slider
into Wall Track
as shown
at left and
replace the
small socket
head cap
screw and
plastic cover.
ATTACH SLIDER TO ULTRA TRACK
Once you have adjusted the
slider to the desired height,
tighten down the Track
Slider using the handle on
the slider as shown.
Once tight, make sure the
handle is positioned so that
it is pointing down as far
as possible. Pull and turn
handle to position.
IF MOUNTING TO THE WALL
IF MOUNTING TO THE
ULTRA WALL TRACK
LTU-W3-A2
ATTACH WALL PLATE TO WALL
Locate the stud and mark the top
hole, drill 11/64 pilot hole and insert
#14 screw and tighten slightly. Using
a level, mark the lower hole and drill
pilot hole, insert #14 screw and, with
the unit level, tighten both screws.
NOTE: ICW supplies #14 wood
screws. If installing onto metal studs,
you will need to replace with proper
metal stud fasteners.
