Mounting
The keypad should be mounted on a wall with adequate air flow around and through it.
The LCD Touchscreen Keypad can operate in either portrait or landscape orientation and can be changed by
loading the appropriate firmware version. For more information, see
Mounting Instructions
1.
Select where to mount the LCD Touchscreen Keypad, ensuring it is mounted a minimum of 1.1m (3.5ft) away
from other wiring such as ACM power, computer data wiring, telephone wiring and wiring to electric lock
devices. Use the
Technical Diagram
provided below as a guide to correctly position the unit.
2.
Hold the rear case half against the wall and mark the mounting holes and cable entry area. The cable entry
area should align with a hole cut through the plaster wall-board. Cables are intended to be run inside the wall.
Use appropriate screws (not supplied) to affix the case to the wall.
3.
Run the wiring. Refer to the
Communication
section of this manual (see page 9) for the electrical connections.
Leave about 20cm (8") of wire protruding through the center of the mounted half of the case and connect the
wiring to the reader electronics.
4.
Align the top of the front body of the reader onto the recessed hinge points at the top of the rear case, then
press gently on the front body until the bottom portion snaps in to place onto the rear case.
PRT-TS50 | LCD Touchscreen Keypad | Installation Manual
6
