Introduction
The Protege Inovonics receiver module is designed to facilitate integration between Protege systems and wireless
Inovonics devices. It works with the Inovonics EN4200 EchoStream receiver to translate incoming Inovonics
signals so they are understood by Protege controllers. The module can link up to 255 Inovonics wireless devices to
each EchoStream receiver.
The receiver module is available in two unit types suitable for the following frequencies:
⦁
PRT-IVO-IF
: for use in the US (902-928 MHz), Australia (915-928 MHz), and New Zealand (922-928 MHz)
⦁
PRT-IVO-IF-EU
: for use in the EU region (868-870 MHz)
Note: the Inovonics receiver module integrates with both Protege GX and Protege WX systems. This manual
provides integration instructions for both.
Key features of the Protege Inovonics Wireless Receiver Module include:
⦁
The ability to connect to Protege systems via RS-485 network or ethernet.
⦁
A web interface for easy network setup and boot mode for firmware updates.
⦁
Firmware upgrade via Trivial File Transfer Protocol (TFTP).
⦁
The linking of Inovonics wireless devices, such as PIRs and remotes, to Protege inputs.
⦁
The linking of Inovonics remotes to Protege users for access control.
PRT-IVO-IF | Protege Inovonics Wireless Receiver Module | Installation Manual
5
