Jumper Configuration
Configuring the Inovonics Frequency Jumper
This section applies only to the NA / AUS / NZ variant of the Inovonics receiver module (PRT-IVO-IF).
The Inovonics EchoStream Receiver can use a range of radio frequencies and must be configured based on your
geographic area using the frequency jumper.
The frequency jumper is labeled
NZ AUS
and is located on the Inovonics side of the board.
Frequency Jumper
N+
N-
NA
NB
NC
CO
MN
O
NZ AUS
NZ AUS
If using the device in
North America
, ensure that the frequency jumper is removed from the pins:
NZ AUS
If using the device in
New Zealand
, place the jumper on the left two pins, marked NZ, to set the frequency range to
921-928 MHz:
NZ AUS
If using the device in
Australia
, place the jumper on the right two pins, marked AUS, to set the frequency range to
915-928 MHz:
NZ AUS
If the device is powered on, remove and restore the power source to apply the change.
PRT-IVO-IF | Protege Inovonics Wireless Receiver Module | Installation Manual
10
