Hybrid Ultra
855-350-050_Rev2.0_Instruction Manual
Page
78
of 84
on the "Send Test E-mail" button, to send a test message to the
designated recipient addresses. The Send Test E-mail box will
show an error message if the system is unable to send the e-mail.
•
Check on the "Communications/E-mail Setup" tab and ensure the
SMTP Server field is the correct address for the e-mail provider,
and the "SMTP Port" is correct (Port should be 25 for most
servers).
•
If the SMTP server requires SSL encryption, ensure the "SMTP
Server requires SSL" checkbox is ticked. Otherwise leave it blank.
•
If the SMTP server requires authentication, ensure that the "SMTP
User Name" and "SMTP Password" fields are correctly entered.
7.4
How do I receive text message alarm notifications?
The unit can send alarm notifications as text messages to a cell phone by
configuring the alarm e-mails to be sent to the mobile phone service
provider. On the "E-mail Setup" page of the GUI enter the address of the
phone in the "Recipient E-mail Address" field.
Example with an AT&T phone: enter the recipient address
"[email protected]", replacing "cell number" with the 10-digit cell phone
number.
Cell address formats for some common North American mobile phone
providers:
AT&T
Verizon
T-Mobile
Virgin Mobile
Bell Mobility
Rogers
Telus
Virgin Mobile (Can)
NOTICE
Verify formatting with the mobile provider.
7.5
How do I configure a router?
To set up the power system with remote internet access when it is located
behind a router, Port Forwarding will need to be enabled on the router to
forward incoming HTTP or HTTPS traffic to the local IP address of the unit.
Refer to your router's user manual for instructions on how to configure Port
Forwarding.