3-12
System Installation
On/Off Power Switch Setup (AT and ATX Power Supplies)
*
To configure the single board computer to accommodate Omnix chassis with an
on/off power switch, follow these steps:
1)
Select jumper pins 2-3 on JP3, AT/ATX Power Select.
2)
Make sure that J12, ATX Power Button Interface, is not connected.
3)
Make sure that J10, ATX Power Control Connector, is not connected.
Figure 3-2. JP3, AT/ATX Power Select, Jumper Pins
* See “Wiring Diagrams” in your chassis user’s guide.
JP3
1
2
3
Select Jumper Pins 2-3
