User Guide
1
Introduction
This manual will help you install the DVI Ranger model 500. The
instructions in this guide assume a general knowledge of computer
installation procedures, familiarity with cabling requirements, and some
understanding of DVI devices.
NOTE
:
Notes give additional information that could make installation
easier.
DVI Ranger Product Contents
When you open your DVI Ranger for the first time you should find the
following items:
•
DVI Ranger User Guide (1)
•
TX unit (1)
•
RX unit (1)
•
AC power adapter (1)
•
DVI M-M cable (2)
To complete the installation, you will also require the following items that
are not included with the product:
•
DVI compatible computer or other video source
•
DVI display
•
Four strands of multimode fiber-optic cable terminated at each end
with duplex LC connectors (if using surface cabling)
OR,
Four strands of multimode fiber-optic cabling terminated at each
end in duplex LC information outlets and four multimode fiber-
optic patch cables with duplex LC connectors (if using premise
cabling)
•
Category 5 Unshielded Twisted Pair (UTP) cable with RJ45
connectors (if using surface cabling),
OR,
Category 5 UTP cabling with two information outlets and two
Category 5 UTP patch cords with RJ45 connectors (if using
premise cabling)
NOTE
: The maximum length of the Category 5 UTP cable, including patch
cords, must not exceed 100m.
NOTE
: The maximum length of the fiber-optic cable, including patch
cords, must not exceed 500m.
