DVI Ranger 500
8
6. Plug one end of the fourth duplex multimode patch cord (not
included) into the Link 2 port on the RX unit. Plug the other end of
this cable into the second LC receptacle on the adjacent information
outlet.
7. Plug one end of the second Category 5 patch cord (not included) into
the DDC port on the RX unit. Plug the other end of this cord into the
RJ45 receptacle on the adjacent information outlet.
NOTE
:
The maximum length of the Category 5 UTP cable, including patch
cords, must not exceed 100 meters.
NOTE
:
It is essential that the fiber connections are not crossed. The left
channel of Link 1 on the TX unit must be connected to the left
channel of Link 1 on the RX unit, and so on.
Completing the Installation
1. Connect the AC power adapter to either the TX unit or RX unit as
convenient. Connect the AC cord to an available AC outlet.
2. Switch on the computer and DVI display.
3. Check that the Power LEDs on the TX unit and RX unit are both
on.
4. Check that the Status LEDs on the TX unit and RX unit are both on.
