DVI Ranger 500
6
Before You Begin
Before you can install the DVI Ranger, you need to prepare your site.
1. Determine where the computer is to be located and set up the
computer.
2. Determine where you want to locate the display
3. Decide whether the power adapter is to be connected to the TX unit
or the RX unit.
4. If you are using surface cabling, ensure you have enough
multimode fiber and Category 5 UTP cabling to connect the two
locations.
OR
If you are using premise cabling, ensure multimode fiber and
Category 5 UTP cabling is installed between the two locations, with
duplex LC and RJ45 information outlets located near both the
computer and the display.
Installing the TX unit
1. Place the TX unit near the computer.
2. Switch off the computer.
3. Connect the DVI output of the computer to the DVI port of the TX
unit using the DVI M-M cable provided.
Installing the RX unit
1. Place the RX unit near the DVI display.
2. Switch off the display.
3. Connect the DVI port of the RX unit to the DVI input of the display
using the DVI M-M cable provided.
