Page 1: ...Propane Gas the low pressure switch must be installed A gas valve conversion kit must be installed and main burner orifices must be replaced with ori fices in this kit or with properly sized orifices...
Page 2: ...ring disconnected 4 Remove the four 4 screws holding the manifold and gas valve to the manifold supports Do not discard any screws 5 Carefully remove the manifold assembly Figure 1 Disassembly Main Bu...
Page 3: ...adjusting screw and give it Stainless eleven full clockwise turns This will set the manifold pressure Spring Red close to required setting for normal operation Steel 5 Replace the regulator cap screw...
Page 4: ...er to Section Checking Input Rate 4 Turn gas valve to OFF Remove the manometer and replace the pressure tap plug and pressure regulator cap screw 5 Start the main burners and check pressure tap plug f...
