Electrical installation
16
iMAT 32VBI-ELV
Pos : 49 /Beko T ec hnis che D okumentati on/Übersc hriften/1/Elektrische Install ati on @ 0\mod_1183638507355_15098.doc x @ 15116 @ 1 @ 1
10 Electrical installation
Pos : 50 /Beko T ec hnis che D okumentati on/Sic her hei t/Gefahr Netzs pannung 1 s/w @ 0\mod_1184148186948_15098.doc x @ 15122 @ @ 1
Danger!
Supply voltage!
There is the risk of an electric shock involving injury or death when coming into contact
with non-insulated components carrying supply voltage.
Pos : 51 /Beko T ec hnis che D okumentati on/Sic her hei t/Maßnahmen N etzs pannung BM 31U/32U/33U @ 7\mod_1390467197804_15098.doc x @ 38070 @ @ 1
Measures:
•
During electric installations, all regulations in force need to be adhered to (e.g. VDE 0100 / IEC 60364).
•
When the control unit is open, service and installation works must only be undertaken when the
system is deactivated.
•
The removed control unit has no IP degree of protection.
•
All types of electrical works must be carried out by authorized and qualified personnel only.
Pos : 52 /Beko T ec hnis che D okumentati on/Installati on/BEKOMAT /El ektrInstallation Hi nweis e BM32U/ElektrInstallati on Hinweis e BM32U/33U allg. @ 4\mod_1357728884079_15098.doc x @ 29541 @ @ 1
Note:
Power supply connection:
1.
Read the permissible supply voltage on the type
plate and make sure this voltage is observed.
2. For the supply voltage, a reliably accessible
separator must be provided close-by (e.g. power
plug or switch), which separates all current-
carrying conductors.
3. At a low voltage supply
(< 50 VAC / < 75 VDC), only use a protective
extra-low-voltage.
4. Carry out installation in accordance with
VDE 0100 / IEC 60364.
5. Observe the terminal assignment.
6. Do not install when the device is energized.
7. Unscrew the screws (1) and remove the upper
part of the cover (2).
8. Unscrew the threaded cable connection (3),
remove the plug (if there is one), and lead the
cable (4) for the power supply through.
9. Connect the cable (4) with terminals X1 (1.1, 1.2)
(5).
10.Install the cables as shown (see also terminal
assignment in the following text).
11.Tighten the threaded cable connection (3) with a
slightly sealing effect.
12.Put on the upper part of the cover (2) and tighten
the screws (1) fingertight.
Summary of Contents for iMAT 32VBI-ELV
Page 26: ...26 iMAT 32VBI ELV...
Page 27: ...iMAT 32VBI ELV 27...
