ICP DAS WISE User Manual
http://wise.icpdas.com
224
Figure 10-35
：
DO action setting page
Follow the steps below:
i
Specify the module and the channel from the dropdown list of
the “Module & Channel” section.
ii
Specify the output value of DO Channel from the dropdown list
of the “Status” field. The output value can be “OFF”, “ON” or
“Pulse Output” (
Pulse Output applies to XV-Board only
).
For
M-7088 belongs to PWM (Pulse width modulation) modules,
the DO channel Action will be “Start PWM” or “Stop PWM”
.
iii
Specify the “Execution Frequency” to be “One Time” or
“Repeat”. Please refer to “
for detail.
iv
Click “OK” button to confirm the settings and return to the Rule
settings page.
10.2.1.3 AO
You can execute an action in AO channel of ICP DAS I/O Module in
THEN/ELSE Action statement; the editing page for AO Action is
shown as follow:
Figure 10-36
：
AO action setting page