ICP DAS USA PET-7060, User Manual

Page: 42 / 156

PET-7000 DIO User Manual, May 2009, V1.00, EMH-013-10----------
42
Chapter 3 Web Configuration Page
3.2. Configuration
3.2.1. Ethernet Settings
The Ethernet settings page can be used to check and change the TCP/IP network settings of
the PET-7000 module.
Table 3-1 TCP/IP network settings
Settings Description Range Factory default
IP 4-byte IP address. Each PET-7000
module needs an IP address so that if
can be identified on the network
X.X.X.1
To
X.X.X.254
192.168.255.1
Gateway 4-byte Gateway. A gateway is a
network address that acts as an
entrance to another network. Usually,
computers that control the traffic within
the network or at the local Internet
Service Provider (ISP) are gateway
nodes.
X.X.X.0
To
X.X.X.254
192.168.0.1
Mask 4-byte subnet Mask. A subnet mask
represents all the network hosts at one
geographic location on the same local
area network. When an Ethernet packet
is sent across the network, the ET-7000
will use the subnet Mask to check
whether the TCP/IP host specified in the
packet is on local network segment.
X.X.X.0
To
X.X.X.255
255.255.0.0