ICP DAS USA ISaGRAF WinCE ViewPAC, User Manual

Page: 169 / 192

ISaGRAF WinCE ViewPAC User Manual , V.1.6 , 1/2017 by ICP DAS
Ap-9
A.8 Linking I-7000 and I-87K Modules For Remote I/O
The ISaGRAF WinCE ViewPAC system can use its COM2:RS-485 (or COM3 + I-7520R) to link to ICP DAS's
"I-7000" and “I-87K” series of remote I/O modules. This configuration can be very useful in
applications that require distributed remote I/O throughout the system.
You can link up to
255 I-7000 or I-87K series remote modules to one ViewPAC controller system (It is
better not to link up to 40 pcs. of I-7000 or I-87K). You must remember to set each I-7000 and I-87K
remote module must have a unique address, and be set to the same baud rate as the ViewPAC
controller system.
For more information regarding setting up and programming an I-7000 / I-87K remote module, please
refer to Chapter 6 - "Linking To I-7000 and I-87K Modules" of the “User’s Manual Of The ISaGRAF
Embedded Controller” .
A.9 Linking To An HMI Interface Device
One of the COM2:RS-485 or COM3:RS-232 (or max. four of the COM5, 6, 7, 8, please refer to
appendix G
& appendix E ) ports of the ISaGRAF WinCE ViewPAC controller system can be used to interface with
additional Human Machine Interface (HMI) devices touch displays.
Please refer to
section A.2 first for setting Modbus RTU port at one of COM2 or COM3. ICP DAS provides
a full line of touch screen displays, such as the "Touch" series screens. The models in the product line
include the Touch 500, Touch 8000, Touch 6000 series products.
For more information regarding interfacing the Touch series of MMI devices to the ViewPAC controller
system, please refer to Chapter 4- "Linking The I-8xx7 To HMI Devices" of the “User’s Manual Of The
ISaGRAF Embedded Controller” .