ICP DAS USA ISaGRAF WinCE ViewPAC, User Manual

Page: 165 / 192

ISaGRAF WinCE ViewPAC User Manual , V.1.6 , 1/2017 by ICP DAS
Ap-5
A.4 Connecting Your PC To The ViewPAC Ethernet Port
Before you can download an ISaGRAF application to the ISaGRAF WinCE ViewPAC controller using the
Ethernet port, you must first setup the Ethernet port to properly communicate with the PC.
On the ViewPAC:
Set IP, Mask and Gateway address:
Please refer to former
section – “A.3: Setting The IP Address For The ViewPAC”
On your PC:
First open an ISaGRAF project and select a program you wish to communicate between your PC and the
ViewPAC controller system. Next, select the "Link Setup" button on the project screen as shown below.
A "PC-PLC Link Parameters" dialog box will appear as shown below. From here select the "Ethernet"
communications option and click on the "Setup" button.
Once you have clicked on the "Setup" button, an "Ethernet Link Parameters" dialog box will appear. Set
the "Port Number" to "
502 " and enter in the Internet address (IP) of the ViewPAC controller.
Once you have entered the appropriate information, click on the "OK" button, and now you have
configured your PC to communicate with the ViewPAC through the Ethernet port.