5. Firmware Upgrade
Please refer to the following steps to upgrade the firmware of module. Here uses
the I-2533CS for example.
Step 1: Power off the I-2533CS.
Step 2: Set the rotary switch to ‘E’ and connect the PC available COM port with the
COM port of the I-2533CS. Users can find the communication cable (CA-0910)
in the product box. When connecting to the COM port of I-2533CS, the TXD pin
of the cable is connected to the TXD pin of the I-2533CS COM port, RXD pin of
the cable is connected to the RXD pin of the I-2533CS COM port, and GND pin
of the cable is connected to the GND pin of the I-2533CS COM port.
Figure 5-1 Wire connection of the RS-232
Step 3: Power on the I-2533CS. Then, the CAN_Err, CAN_Tx, CAN_Rx, FB_Err LEDs
will flash per 500 milliseconds.
Step 4: Get the “Firmware Update Tool” and firmware fire.
The software is located at:
Fieldbus_CD:\CAN\Converter\I-2533CS\Software\Tool
The firmware is located at:
Fieldbus_CD:\CAN\Converter\I-2533CS\Firmware\
http://www.icpdas.com/products/Remote_IO/can_bus/i-2533cs.htm
I-2533CS series CAN to Single Mode Fiber Bridge User Manual (version 1.0.0)
Page: 34
Copyright © 2013 ICP DAS Co., Ltd. All Rights Reserved. E-mail: [email protected]
ГК
Атлант
Инжиниринг
–
официальный
представитель
в
РФ
и
СНГ
+7(495)109-02-08 [email protected] www.bbrc.ru