ET-2200 Series Ethernet I/O Modules
Copyright © 2020 ICP DAS CO., Ltd. All Rights Reserved.
-89 -
5.3
Several Modules Pulling the Remote DI
(M-to-1) (Pull Mode)
Step 1: Connect the device to a Network, a PC and a Power supply.
Confirm that the ET-2200 series modules and remote slave device are functioning correctly. Refer to
for more details. An example configuration shown below:
Note that ET-2260 and PETL-7060 module is used in this example.
Step 2: Configure the Ethernet Settings
Contact your Network Administrator to obtain the correct network configuration information for
the ET-2200 series modules and
remote slave device (e.g., ET-2260 #1,
#2 and PETL-7060), such as the IP
Address, Subnet Mask, and Gateway
“Configuring the Network Settings”
for more details.
Figure 5-3.1
Figure 5-3.2
