ICOP Technology PDX3-090T, User Manual, Page: 16 / 46

PPC-
090T User’s Manual
IUMPPC090T-01 Ver.1.10A Jun, 2018
10
1.5 Panel Mounting Instruction
1. Cut a mounting hole in the panel. (Refer to PPC
‐
090T Dimensions on page
11~12.) (Note 1)
2. Check and remove the twelve M3 screws in a diagonal pattern as image below if
necessary.
3. Place PPC
‐
090T face
‐
down on a clean, flat surface.
4. Slide the panel cutout around the back of PPC
‐
090T, until the panel rests
directly on the gasket. Make sure the screw holes align with the screw holes on
PPC
‐
090T.
5. The screw size is M3*L (L=wall thi 6.0mm) (Note 2)
6. Insert all twelve M3 screws into the screw holes. (Note 2)
7. Finger-tighten the M3 screws. Finish tightening the M3 screws in a diagonal
pattern using an M3 screw driver (see the image as below); maximum torque
0.44Nm (4.5 kgf
‐
cm).