PBSW-090T
User’s Manual
IUMPBSW090T-01 Ver.1.0A July, 2020
11
1.5 Mounting Instruction
Panel Mounting
Cut a mounting hole in the panel. (Refer to PBSW
‐
090T Dimensions on page 10) (Note 1)
Check and remove the twelve M3 screws in a diagonal pattern as image below if necessary.
Place PBSW
‐
090T face
‐
down on a clean, flat surface.
Slide the panel cutout around the back of PBSW
‐
090T, until the panel rests directly on the
gasket. Make sure the screw holes align with the screw holes on PBSW
‐
090T.
The screw size is M3*L (L=wall thi 6.0mm) (Note 2)
Insert all twelve M3 screws into the screw holes. (Note 2)
Finger-tighten the M3 screws. Finish tightening the M3 screws in a diagonal pattern using an M3
screw driver (see the image as below); maximum torque 1.18Nm (12 kgf
‐
cm).
