iConnectivity mio10, Owner'S Manual

Page: 16 / 21

12
MIDI Port Filters Page
This setting allows specific kinds of MIDI data to be removed (filtered) from each port on either
the input or output path. In the Filter Type selection box, choose between Input and Output to
select where the filtering is to be applied.
Active Sensing and Program Changes are being filtered from the USB 1 / Port “DIN 1” input in
the following example.
MIDI Channel Remap Page
This setting allows MIDI data to be re-assigned from one channel to another on either the input
or output path. Choose specific message types on specific channels by clicking on the
corresponding box in the matrix. Edit the “Remap to Channel” entry below the channel number
to indicate which channel the messages should be re-assigned to. In the example below, Pitch
Bend messages on channel 8 of port 1 (“DIN 1”) from the computer are remapped to channel 2
before routing the data to its destination port (DIN 1). The Pitch Bend messages will be
removed from channel 8 and inserted into channel 2 instead.