Mounting
10
Step 1: Insert the head of a screwdriver into the opening of the spring locking piece at the
bottom from the left. Lift the handle of the screwdriver to open the spring locking piece of the
connecting seat, as shown on the left of the following figure.
Step 2: Move the device in direction 2 until the bottom of the device is detached from the DIN
rail. Then move the device in direction 3 and uplift the device until the top of the connecting
seat is detached from the DIN rail. In this way, the device is removed from the DIN rail
completely.
Figure 10 DIN-Rail 2 Dismounting
3.2.2 Panel Mounting
Note:
To adopt panel mounting, you need to purchase the plate for panel mounting (optional).
Mounting
Step 1: Use screws to fix the plate for panel mounting to the rear panel of the device.
Step 2: Select the mounting position (on a wall or inner wall of a cabinet) for the device and
guarantee adequate space and heat dissipation for it.
Step 3: Punch four holes in the selected position according to the dimensions for panel
mounting. Insert four screws into the four holes respectively, and turn the screws with a
screwdriver until about a 5mm distance is left between each screw head and the wall.
ICON Industrial Engineering (IIE)
