9
Rear Panel
3
4
5
2
6
1
1. USB 2.0 connector (Type C)
Connect it with the provided USB cable Type C to your Mac/PC or your
iOS device camera kit’s USB connector. Your Mac/PC must have a USB2.0
connector in order to run the full speed of Cube2Nano Dyna .
2. HI-Z input
This is a high impedance input for guitar/bass.
3. Line outputs L/R
These are unbalanced analog outputs on standard 1/4″ TS connectors at +6dBU
line level.
4. Stereo output L/R
This is an unbalanced analog output on a standard 3.5mm stereo connector.
(
Note:
Master level control will only adjust the output level of both the Line
output L/R and the 3.5mm stereo output.)
5. Smart Device I/O (Digital - Type C & Analog - 3.5mm TRRS)
These ports allow you to connect your smart device and your Mac/PC
simultaneously so you may process the audio signal wih your Mac/PC before
delivering signal to the smart device for live streaming application.
Digital - Type C jack for connecting directly to the digital jack of the smart
device (OTG adapter required)
Analog - TRRS stereo jack for connecting directly to smart device’s audio I/O
6. Power supply connector (USB Type C)
Cube2Nano Dyna is USB-bus powered. If your computer does not supply
sufficient power, connect an ICON 5VDC power supply adapter to this jack. Or
you may try to use your smart phone power adapter with the correct cable type
(USB Type C). Normally it should work and provide enough power to the device.
(
Note:
You can get the power adapter from ICON distributors/dealers near you)
(
Note:
External power adapter is needed if the Cube2Nano Dyna is us as a
standalone unit without a Mac or PC)
