ICON A5, Maintenance Manual

Page: 470 / 836

13-50 INSTRUMENTS (AND AVIONICS) / ELT
ICON A5 / MAINTENANCE MANUAL CHANGE C2
CHA
P
TER
13
R
ELATED
I
NFORMATION
:
"ELT Access" on page 13-42
"ELT Battery Self Test" on page 13-47
13.5.4.2 ELT Remote Control Panel Battery Replacement
Directions for replacing the ELT remote control panel indicator battery.
T
ASK
I
NFORMATION
:
Type of Maintenance
Line
Level of Certification
LSA-RM
Task Specific Training Required
No
Special Tools Required
None
Parts Required
Duracell PX28L 6 volt lithium battery, or equivalent
Aircraft System and Number
10—Instruments (and Avionics)
Consumables
None
The Remote Control Panel Indicator (RCPI) is designed to be powered by a single Duracell PX28L 6
volt lithium battery, or equivalent. Alkaline batteries, such as Eveready A 544, or equivalent may also be
used. Under normal operating conditions, the lithium battery must be replaced every 10 years. The alka-
line batteries must be replaced every 5 years. If the ELT is activated for an unknown period of time, the
battery must be replaced. For additional information see the ACK Technologies Inc. Model E-04 ELT
Installation/Operation Manual, Section 4.
NOTE
: The Audio Annunciator Battery should be checked and replaced at
the same time. (See “ELT Audio Alert Indicator Battery Replace-
ment” on page 13-52.)
T
ASK
I
NSTRUCTIONS
:
1. Remove the overhead console bezel and overhead console mount. (See “Overhead Console
Component Replacement” on page 13-15.)
2. Locate the ELT RCPI.
3. Use a T10 Torx driver to remove the four 6-32 screws attaching the black ICA009273 bracket
to the RCPI and orange audio alert indicator, then remove the bracket and remove the RCPI.