6
ASSEMBLY
1
2
2. Identify the Rear Stabilizer (4), which has
Leveling Caps (23).
Attach the Rear Stabilizer (4) to the Frame (1)
with two M8 x 65mm Carriage Bolts (73), two
M8 Curved Washers (65), and two M8 Acorn
Nuts (82);
start both Carriage Bolts, and then
tighten the Acorn Nuts.
23
4
1
23
65
65
82
82
73
• Assembly requires two persons.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until you finish all assembly steps.
• To identify small parts, see page 5.
• Left parts are marked “L” or “Left” and right parts
are marked “R” or “Right.”
• To identify small parts, see Page 5
In addition to the included tool(s), assembly
requires the following tools:
one Phillips screwdriver
one adjustable wrench
one pair of pliers
Assembly may be easier if you have a set of
wrenches. To avoid damaging parts, do not use
power tools.
1.
To register your product and activate your
warranty in the UK,
go to iconsupport.eu. If
you do not have internet access, call Customer
Service (see the front cover of this manual).