7
CONNECTION PORT SETTINgS
7-28
EXT I/O (EXT) screen
Connection Port Settings > EXT I/O (EXT)
■
Transceiver Control
These items are displayed when “Transceiver” is selected as a connected unit.
(Connection Port Settings > EXT I/O (EXT) > EXT I/O Port Mode > EXT I/O 1 ~ 4 > Connected Unit)
(Connection Port Settings > EXT I/O (EXT) > EXT I/O > EXT I/O Port)
Edit the control settings for transceivers connected to the EXT1 ~ EXT4 ports.
These items are displayed only when “Connection Unit” is set to “Transceiver.”
1
2
3
4
5
6
7
8
9
1
Prioritized Receive
Select “Enable” to keep receiving and inhibit the transmission, while
the transceiver is receiving. The default value differs, depending on the
Transceiver Mode.
2
PTT Control
Select the audio transmission method.
(Default: RTP)
•
VOX
:
According to the input audio signal level.
•
RTP
:
The RoIP gateway sends the PTT control signal to the
transceiver during receiving an applicable RTP packet.
•
PTT Always-ON
: The RoIP gateway always sends the PTT control signal to
the transceiver to transmit.
•
No PTT Control
: The RoIP gateway does not send the PTT control signal to
the transceiver.
3
Receive Detection
Select the received audio detection method. The default value differs,
depending on the Transceiver Mode.
•
VOX
:
According to the input audio signal level.
•
SQL
:
According to the squelch status (Open/Close)
When setting to “SQL,” set also Pull-up Control ON or OFF.
•
Always Receive
: Always in the receive mode.
•
PC CMD
:
According to the PC command. (Displayed only when the
Transceiver Model is set to “general Settings.”)
4
Insert RX Audio to TX Audio
Select “Enable” to mix the audio from the repeater with the audio from
the telephone.
(Default: Disable)
L
When “Enable” is selected, select “Disable” in Prioritized Receive (
1
).
5
TX Volume
Adjust the RoIP gateway’s transmitting audio level that is sent to the
connected transceiver.
(Default: 0)
• Range: –12 ~ +6 (dB)
L
2
,
8
and
9
are displayed only when the Transceiver Model is set to “general Setting.”
L
Only
5
and
6
are displayed when the Transceiver Model is set to “IC-SAT100.”