Icom VE-PG2, Instruction Manual, Page: 78 / 160

78
VE-PG2 SETTING SCREEN
3
3-8 TRX/EXT EXT I��u�� (EXT IN)
ï EXT v����� ���������l ���������g
Set the external equipment signal’s input connection port, input AF signal’s the ’s input connection port, input AF signal’s the s input connection port, input AF signal’s the ’s the s the
available timing, etc that input from the [IN] port, in this screen.
Place the mouse pointer on �Connection setting,�� and then on �TRX/EXT,�� and then
�Connection setting,�� and then on �TRX/EXT,�� and then Connection setting,�� and then on �TRX/EXT,�� and then ,�� and then on �TRX/EXT,�� and then �� and then on �TRX/EXT,�� and then and then
click �EXT Input (EXT IN) �EXT Input (EXT IN)�� shown on the list.
q
I��u�� ������������ �����
Set the output port for the AF signal from the [IN] port.
(Default: IP network)
• EXT Output : Sends the AF signal to the [OUT] port.
[
NOTE]
This item is not selectable if you set �Combined mode�� option in �EXT
I/O port�� on �Operating mode.��
• IP network : Sends the AF signal to the [LAN] port.
[ NOTE]
If you set [IP Communication–EXT Input(EXT IN)] or [IP Communication
–EXT I/O port (EXT)], the AF signal is sent to them at the same time.
• Emergency notice : Sends the AF signal to the device which is selected in �Emergency
notice.��
• You must set �Emergency notice�� to send the emergency notice (p. 129).
• The emergency communication has priority over normal communication.
q
w
e
r
t
■
Connection setting (Bridge mode)