Icom VE-PG2, Instruction Manual, Page: 71 / 160

71
VE-PG2 SETTING SCREEN
3
2
3
4
5
6
7
8
9
10
11
1
3-6 IP �����w��k ������������ E����g����� ��������
ï
IP �����w��k ������������ ���������g
Set the external equipment’s emergency signal destination through the [IN] port, in
this screen.
Place the mouse pointer on �Connection setting,�� and then on �IP network
�Connection setting,�� and then on �IP network Connection setting,�� and then on �IP network ,�� and then on �IP network �� and then on �IP network
connection,�� and then click �Emergency notice and then click �Emergency notice click �Emergency notice �Emergency notice�� shown on the list.
• You cannot set these settings when �During transmit�� or �During receive�� is displayed in the
status field of �IP network connection status.��
• The default settings (
q
–
r
) are dependent on �IP communication mode setting.��
q
C����������� IP ��������
Set the destination VE-PG2’s IP address.
(Default: Multicast mode: 239.255.255.1, Unicast mode: Blank)
• When �IP communication mode setting�� is set to �Multicast mode,�� set the IP address to
�224.0.0.0��–�239.255.255.255.��
To operate the VE-PG2 in the Multicast mode, set ALL the VE-PG2s’ Connection IP address
to same address.
• When �IP communication mode setting�� is set to �Unicast mode,�� set the destination VE-PG2’s
IP address.
You can also set domain name (up to 63 characters) instead of the IP address.
q
w
e
r