68
VE-PG2 SETTING SCREEN
3
3-5 IP �����w��k ������������ EXT I/O (EXT)
ï
IP �����w��k ������������ ���������g
Set the signal destination from the external equipment through both the [IN] and
[OUT] ports, in this screen.
Place the mouse pointer on �Connection setting,�� and then on �IP network
�Connection setting,�� and then on �IP network
Connection setting,�� and then on �IP network
,�� and then on �IP network
�� and then on �IP network
connection,�� and then click �EXT I/O (EXT)
and then click �EXT I/O (EXT)
click �EXT I/O (EXT)
�EXT I/O (EXT)
EXT I/O (EXT)�� shown on the list.
• You cannot set these settings when �During transmit�� or �During receive�� is displayed in the
status field of �IP network connection status.��
• The default settings (
q
–
r
) are dependent on �IP communication mode setting.��
q
C����������� IP ��������
Set the destination VE-PG2’s IP address.
(Default: Multicast mode: 239.255.255.1, Unicast mode: Blank)
• When �IP communication mode setting�� is set to �Multicast mode,�� set the IP address to
�224.0.0.0��–�239.255.255.255.��
To operate the VE-PG2 in the Multicast mode, set ALL the VE-PG2s’ Connection IP address
to same address.
• When �IP communication mode setting�� is set to �Unicast mode,�� set the destination VE-PG2’
s IP address.
You can also set domain name (up to 63 characters) instead of the IP address.
■
Connection setting (Bridge mode)
q
w
e
r