65
VE-PG2 SETTING SCREEN
3
2
3
4
5
6
7
8
9
10
11
1
3-4 IP �����w��k ������������ EXT Ou���u�� (EXT OUT)
ï
IP �����w��k ������������ ���������g
Set the signal destination from the external equipment through the [OUT] port, in
this screen.
Place the mouse pointer on �Connection setting,�� and then on �IP network
�Connection setting,�� and then on �IP network
Connection setting,�� and then on �IP network
,�� and then on �IP network
�� and then on �IP network
connection,�� and then click �EXT Output (EXT OUT)
and then click �EXT Output (EXT OUT)
click �EXT Output (EXT OUT)
�EXT Output (EXT OUT)
EXT Output (EXT OUT)�� shown on the list.
• You cannot set these settings when �During receive�� is displayed in the status field of �IP
network connection status.��
• The default settings (
q
–
e
) are dependent on �IP communication mode setting.��
q
C����������� IP ��������
Set the destination VE-PG2’s IP address.
(Default: Multicast mode: 239.255.255.1, Unicast mode: Blank)
• When �IP communication mode setting�� is set to �Multicast mode,�� set the IP address to
�224.0.0.0��–�239.255.255.255.��
To operate the VE-PG2 in the Multicast mode, set ALL the VE-PG2s’ Connection IP address
to same address.
• When �IP communication mode setting�� is set to �Unicast mode,�� set the destination VE-PG2’
s IP address.
You can also set domain name (up to 63 characters) instead of the IP address.
q
w
e