21
5
BASIC OPERATION
■
AIS settings
AIS settings can be customized in “AIS settings” on the Menu screen.
TX
Turn the TX function ON or OFF.
WARNING:
If this setting is “OFF,” AIS
data is not transmitted. Therefore, your
vessel will not be visible to other vessels,
and this could result in a collision.
ON: AIS data is transmitted.
OFF: AIS data is not transmitted.
North up/Course up
You can select the display type for the AIS
plotter screen.
North up: The top of the plotter screen
represents North.
Course up: The top of the plotter screen
represents the direction your
vessel’s course over ground.
AIS display setting
You can select whether or not to limit the
AIS or waypoint targets that are displayed
on the plotter display. You can easily see
the plotter display.
L
The indicator is displayed on the plotter
display. (p. 13)
L
The waypoint for navigation is displayed,
regardless of this setting.
All targets:
All targets are displayed.
Danger only: Only Danger targets are
displayed.
Friends only: Only Friend targets are
displayed.
Waypoint only: Only waypoints are
displayed.
CPA/TCPA
z
Alarm
You can select whether or not to turn
the following alarm functions ON or
OFF.
•CPA/TCPA alarm function:
The alarm for when a vessel’s CPA is
closer, and TCPA is less than the set
value.
•
Danger target lost alarm function:
The alarm for when a danger target is
regarded as a “Lost target.” (p. 30)
ON: The alarm functions are ON.
An alarm sounds, and a popup
screen is displayed.
L
The alarm may not sound,
depending on the setting. (p. 36)
OFF: The alarm functions are OFF.
z
CPA
Set a CPA (Closest Point of Approach)
value between 0.01 and 6.00 NM (in
0.01 NM steps), or between 0.02 and
11.11 km (in 0.01 km steps), for the
alarm function.
z
TCPA
Set a TCPA (Time to CPA) value
between 1 and 60 minutes (in 1 minute
steps) for the alarm function.
Summary of Contents for MA-510TR
Page 60: ......
Page 62: ...MEMO ...
Page 63: ...1 7 4 10 15 18 2 8 13 5 11 16 3 9 14 6 12 17 MEMO ...
