Icom IP1000C, Instruction Manual, Page: 85 / 246

4
ABOUT THE SETTING SCREEN
4-32
8. [Transceiver Settings] Menu
■
Transceiver Management
The IP1000C can monitor the registered WLAN transceivers and IP100FSs. And if necessary, The IP1000C
can reboot the registered WLAN transceivers at the same time.
1
Selection Box ������ Click a Selection Box to add a check mark to the WLAN transceiver that
you want to reboot.
L
You cannot select an IP100FS, or the WLAN transceivers that has
“Disconnected” displayed in [Registration Status].
L
By clicking the [All] Box, you can select or cancel all WLAN transceivers in
the list.
2
Registration Status ��� Displays the WLAN transceivers’ or IP100FSs’ Registration Status as
either the “Connected” or “Disconnected.”
L
If the WLAN transceiver is turned OFF or IP100FS’s application is not
running, displays “Disconnected.”
L
When the IP1000C sends the reboot command to an WLAN transceiver from
the [Transceiver Management] menu, the following status are displayed:
“Receiving reboot command,” “Reboot command reception success,”
“Reboot command reception failed,” “Ready to reboot” “Rebooting,”
“Updating,” “Update failed,” “Downloading,” “Status notifi cation failed,” “Low
battery,” and “Programming with software.”
3
IP Address ������� Displays the IP Addresses of the WLAN transceivers or IP100FSs.
L
When [Registration Status] displays “Disconnected,” “–” is displayed.
4
Current Status ����� Displays the Current Status of the WLAN transceivers.
(Example: Meeting)
Information
L
•If the Status function is set to OFF, “–” is displayed.
•If you click the <Refresh> button (
7
), the latest status will be displayed.
•When the WLAN transceiver is remotely locked by the IP100FS, and it cannot
communicate with others or cannot transmit, “Transmit and receive disabled”
or “Transmit disabled” is displayed.
•If the WLAN transceiver is sending an emergency call, “Emergency” is
displayed.
1
2 3 4 5 6
7
8
9
10
(This is only an example.)
L
A WLAN transceiver is displayed in bold when the setting is changed and the reboot is required.
[Transceiver Settings]–[Transceiver
Management]