Icom id- rp2, Instruction Manual, Page: 11 / 56

8
3
PANEL DESCRIPTIONS
ID-RP2L
■
q
POWER CABLE CONNECTOR [DC13.8V]
(p. 10)
Connects to the ID-RP2C to be supplied the DC
power.
Cable length: Approximately 30 m; 100 ft
w
ANTENNA CONNECTOR [ANT] (p. 10)
Connects an optional parabolic antenna AH-106 or
AH-107.
e
STATUS INDICATOR [STATUS]
Indicates the following unit conditions.
• Light : The power is ON and func -
tioning correctly.
• Flashing slowly : Unlocked PLL
(Reboot the
ID-RP2L. If the indicator is still
flashing even after rebooting,
contact authorized Icom dealer
or distributor.)
• Flashing fast : Setting data malfunction.
( Data initializing and re-setting
are required using with the ID-
RP2L utility software.)
• Light off : There is no power to the unit.
(Not available in European countries)
r
TEST PLUG [TEST]
(p. 17)
Connects the supplied test plug* when adjusting
the parabolic antenna beam.
Test mode is automatically selected when connect-
ing the test plug.
IMPORTANT!:
Attach the waterproof cap during
normal operation.
q
RSSI output
w
TEST
e
GND
r
GND
Front view
* See p. 17 for test plug assembling and connections de-
tails.
t
DATA CABLE CONNECTOR B [DATA B]
(p. 10)
Connects to the ID-RP2C for transmit/receive sig -
nal data and control signal communications.
Cable length: Approximately 30 m; 100 ft
y
DATA CABLE CONNECTOR A [DATA A]
(p. 10)
Connects to the ID-RP2C for transmit/receive sig -
nal data and control signal communications.
Cable length: Approximately 30 m; 100 ft
q w
e
r
t
y
2001 NEW