8
DTMF MEMORY
8-2
DTMF codes are used for autopatching, controlling
other equipment, and so on. The transceiver has up to
16 DTMF memory channels (d0–dF) for up to 24 digits
often-used DTMF codes.
1. Push [FUNC], and then push [DTMF-M] to enter
the DTMF memory mode.
2. Push [
Y
] or [
Z
] to select the desired blank DTMF
memory channel.
• The selected DTMF memory channel blinks.
• If programmed, the previously programmed
DTMF code is displayed.
NOTE:
Previously programmed code sequence in
the selected DTMF memory channel will be cleared
by the following operation.
3. Push [FUNC], and then hold down [DTMF-M] for 1
second to enter the DTMF memory programming
mode.
• “_ _ _ _ _” is displayed.
4. Push a key to input the desired DTMF code.
• Refer to the illustration below for the DTMF
code assignment.
L
If a digit is mistakenly input, push [PTT]
momentarily, and then repeat from step 3.
5. Repeat step 4, until the desired DTMF code
sequence (up to 24 digits) is complete.
• When the 6th character is set, the icon displays
the next blank digit group.
6. Push [PTT] to save the channel and exit the
DTMF memory programming mode.
• After the 24th digit is input, the transceiver
automatically saves the code sequence and
returns to the DTMF memory mode (step 2).
7. Push [VFO/MR/CALL] to exit the DTMF memory
mode.
DTMF code assignment
Numeric input
“A”
“B”
“C”
“D”
“*(E)” “# (F)”
Programming mode indication
The programming mode consists of 5 groups.
Group
Digits
Icon
1st
1st to 5th
No icon.
2nd
6th to 10th
“ ” is displayed.
3rd
11th to 15th
“ ” is displayed.
4th
16th to 20th
“ ” is displayed.
5th
21st to 24th
“ ” blinks.
The next page appears when
the 6th digit has been input.
Example: Programming “123456” into the DTMF
memory channel “d3.”
Push keys, until the desired DTMF code is complete.
Push [PTT].
(DTMF memory mode)
( DTMF memory
programming mode)
Push
, and then push
.
Push
or
to select DTMF memory channel “d3.”
Push
, and then hold down
for 1 second.
Push
to exit the DTMF memory mode.
Programming a DTMF code sequence