Icom IC-V80, Instruction Manual

Page: 19 / 59

13
Previous view
■
Selecting passband width
Set both the transmission and reception passband width
to wide or narrow.
q
Push [FUNC](
M
) , and then push [SET](8) to enter
the Set mode.
w
Push [
Y
] or [
Z
] to select the passband width item
(W/n).
e
Rotate [VOL] to select the passband width.
• “W” : Wide (FM mode).
• “n” : Narrow (FM-N mode).
r
Push [# ENT] to exit the Set mode.
■
Selecting a tuning step
The transceiver has 8 tuning step options;
• 5 kHz • 10 kHz • 12.5 kHz • 15 kHz
• 20 kHz • 25 kHz • 30 kHz • 50 kHz
The tuning step can be selected in the Set mode.
q
Push [FUNC](
M
) , and then push [SET](8) to enter
the Set mode.
w
Push [
Y
] or [
Z
] to select the tuning step item (tS).
e
Rotate [VOL] to select the desired tuning step.
r
Push [# ENT] to exit the Set mode.
■
Setting a frequency
D
Using [
Y
] or [
Z
]
q
If necessary, push [VFO/MR/CALL] several times to
select the VFO mode.
w
Push [
Y
] or [
Z
] to set a frequency.
• The frequency changes according to the selected tuning
step.
D
Using the keypad
q
If necessary, push [VFO/MR/CALL] several times to
select the VFO mode.
w
To enter the desired frequency, enter 6 digits, start-
ing from the 100 MHz digit.
• Entering two or three* to fi ve digits, and then pushing [# ENT] ,
also sets the frequency. (*Depending on the transceiver
version)
• If the entered frequency is outside of the frequency range,
the previously displayed frequency is automatically recalled.
(20 kHz is selected)
• The “Tuning step” item in the Set mode
(FM mode is selected)
• The “Passband width” item in the Set mode
(FM-N mode is selected)
Push
Push
• Example 1— entering 145.525 MHz
• Example — selecting 145.040 MHz
• Example 2— entering 144.800 MHz
Push .
(When the selected tuning step is 20 kHz.)
Push .
4
BASIC OPERATION