1-5
1
ADVANCED OPERATIONS
You can set a specific volume level between 0 and 32
Once [BANK OPT] is pushed, the volume level is
changed to the set value
D
Assigning the Temporary Volume
function to [BANK OPT]
1 While holding down [SET LOCK], hold down [ ]
for 1 second to enter the Initial Set mode
2 Repeatedly push [SET LOCK] or [MONI ANM PA]
to select “OK” ([BANK OPT] key)
3 Rotate [DIAL] to select “TVo”
4 Push [ ] to save and exit the Initial Set mode
D
Setting the Temporary Volume
1 While holding down [SET LOCK], hold down [ ]
for 1 second to enter the Initial Set mode
2 Repeatedly push [SET LOCK] or [MONI ANM PA]
to select “TV” (Temporary volume)
3 Rotate [DIAL] to set the volume level
4 Push [ ] to save and exit the Initial Set mode
NOTE:
You can use the function as “One-Touch Mute”
by setting volume at level 0
D
Using the Temporary Volume function
IMPORTANT:
When another function is assigned to
[BANK OPT], this function cannot be used
z
Push [BANK OPT]
• The volume level is changed to the set value
• “VOL” and the changed volume level is displayed
L
Push [BANK OPT] again to go back to the original level
L
To turn the function ON or OFF using the HM-133V,
push [BANK/OPTION]
TIP: Changing the volume level when the function
is turned ON
• When rotating [VOL], the function is turned OFF,
and the volume level is changed to the value
corresponding to the [VOL] level
•
When [VOL▲ 0 TONE-2] or [VOL▼
TONE-1]
on the HM-133V is pushed, the function is turned
OFF, and the volume level goes up or down from
the set value
Temporary Volume function
LOCK
SET
ANM
MONI
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
When “TVo” (Temporary Volume/Option) is selected in
the [BANK OPT] key item
The Temporary volume item
Push [BANK OPT]
The changed volume level is displayed
“VOL” is displayed
SET
ANM
MONI
AO
NAR
MID
LOW
