23
6
SCAN OPERATION (Except for the Dutch version)
New2001
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
■
Favorite channels
You can quickly recall often-used channels by setting them
as Favorite channels.
All channels are set as Favorite channels by default.
D
Setting
1. Rotate [CH/ENT] to select a channel.
2. Push [Favorite]
to set the channel as a Favorite
channel.
•
“
” is displayed.
■
Starting a scan
1. Push [Scan]
to start a scan.
• During a Priority scan, “SCAN 16” is displayed.
• During a Normal scan, “SCAN” is displayed.
2. Push [Scan]
again to cancel the scan.
• “SCAN 16” or “SCAN” disappears.
D
Selecting
z
Push [
∫
] or [
√
] on the microphone.
• Non-Favorite channels are skipped and not displayed.
• When the “FAV on MIC” item is set to “OFF,” you can select all
D
Clearing
1. Select a Favorite channel to clear.
2. Push [Favorite]
to clear the channel as the
Favorite channel.
•
“
” disappears.
Example:
Starting a priority scan.
Scanning starts
When a signal
is received
NOTE:
• When a signal is received,
the scan pauses until the signal
disappears, or resumes after pausing for 5 seconds, depending
on the “Scan Timer” setting. (p. 88)
• You can check the scanning channel, change the scan direction,
or manually resume the scan by pushing [
∫
] or [
√
] on either the
transceiver or the microphone.
• A beep tone sounds and “16” blinks when a signal is received on
Channel 16 during a Priority scan.
• In order to properly receive signals, you must adjust the squelch
Push
TIP:
You can clear all Favorite channels in the Menu screen.
TIP:
You can select all channels by rotating [CH/ENT] or
pushing [
∫
] or [
√
] on the transceiver. (p. 14)
