Icom IC-F6062D, Operating Manual, Page: 4 / 32

1
1
PREPARATION
■
Programmable function keys
The following functions can be assigned to [UP] , [DOWN] ,
[P0]
,
[P1]
,
[P2]
,
[P3]
and
[P4]
programmable function keys.
Consult your Icom dealer or system operator for details con-
cerning your transceiver’s programming.
If the programmable function names are bracketed in the fol-
lowing explanations, the specific key is used to activate the
function.
D For only BIIS 1200 operation
The following key function is required for BIIS 1200 operation.
BIIS BUTTON
➥
Push to enter the call code memory mode.
• Push
[CH Up]
or
[CH Down]
to select a desired Individual or
Group ID.
➥
While in the call code memory mode, push to enter the
message selection mode.
• Push
[CH Up]
or
[CH Down]
to select a desired status message
or Short Data Message (SDM).
➥
While in the message selection mode, push to return to the
stand-by mode.
➥
Hold down for 1 second to toggle between the memory
channel mode and the queue channel mode.
➥
While in the queue channel mode, push to toggle between
the queue channel mode and the received message
mode.
“  ” appears above the key assigned to the BIIS Button
function, when it is activated.
D For only dPMR operation
The following key functions are required for dPMR operation.
dPMR BUTTON
➥
Push to enter the ID selection mode.
• Push
[CH Up]
or
[CH Down]
to select a desired Individual or
Talkgroup ID.
➥
While in the ID selection mode, push to enter the application
selection mode.
• Push
[CH Up]
or
[CH Down]
to select a desired application from
“
STATUS,
” “
MESSAGE,
” “
STAT POL,
” “
LISTENING,
” “
STUN,
”
“ KILL, ” “ REVIVE ” and “ CALL LOG. ”
➥
If you select
“
STATUS
” or “
MESSAGE
”
in the application selec-
tion mode, push to enter the message selection mode.
• Push
[CH Up]
or
[CH Down]
to select a desired message.
➥
While in the application selection mode, push to return to
the stand-by mode.
CLEAR
After communication is finished, push this key to send a ‘Dis-
connect’ signal to terminate the connection.
Depending on the pre-programmed settings, the Priority A
channel is automatically selected after a ‘Disconnect’ sig-
nal terminates a connection.