3
dPMR OPERATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
26
■
Position data transmission
When a GPS receiver is connected to the transceiver, the
position data (longitude and latitude) can be automatically
transmitted. Ask your dealer or system operator for connec-
tion details.
The position data is transmitted:
• When the GPS Request status message is received.
- Set a status message as the GPS Request one in the ‘GPS
Request Status’ item.
• At the end of a Voice call.
- Set the ‘Send with Voice Call’ item to ‘Enable.’
• After sending a status message.
- Set the ‘Send with Status Call’ item to “Enable.”
• After sending an SDM.
- Set the ‘Send with SDM Call’ item to “Enable.”
• After making an Emergency call.
- Set the ‘Send with Emergency’ item to ‘Enable.’
• By the Automatic Position Transmission function.
When the function is activated, the transceiver auto-
matically transmits position data according to the ‘Time
Marker’ and ‘Interval Timer’ settings.
- Set the ‘Auto’ item to “Enable.”
NOTE:
Configure the position data transmission settings
using the CS-F3160/F5060 (dPMR)
cloning
software
.
Ask your dealer for details.
■
Status message transmission
Status messages can be automatically transmitted:
• When the transceiver is turned ON or OFF
- Select a status message to be transmitted in the ‘Power ON Sta-
tus’ or ‘Power OFF Status’ item, respectively.
- Select a target station ID in the ‘Power Status ID’ item.
• At the end of a Voice call
- Select a Status Message to be transmitted in the ‘Send with
Voice Call’ item.
NOTE:
Configure the status message transmission set-
tings using the CS-F3160/F5060 (dPMR)
cloning
soft
-
ware
. Ask your dealer for details.