Icom IC-F3062T, Instruction Manual

Page: 23 / 48

19
4
BIIS OPERATION
4
Transmitting a call
■
A total of 3 ways for code selection are available—selecting
the call code from memory, entering the call code from the
keypad and calling back from the queue channel record.
Using call memory D
While in the standby condition, push [Digital Button] to en-
q
ter the call code memory channel selection mode.
• “ ” appears.
TXCE CALL TXC BIFN
CALLING
0500
Appears
Push [CH Up] or [CH Down] to select the desired call
w
code.
Push [Call] or [PTT]* to call.
e
* PTT call can be made only when PTT call capability is permit-
ted.
NOTE:
When no answer back is received, the trans-
ceiver repeats the call 3 times (default) automatically,
and
“
WAIT
” is displayed during each call. However, an
error beep sounds and
“
FAILED
”
is displayed when no
answer back is received after the calls.
Push [PTT] to transmit; release to receive.
r
Push [Moni(Audi)] to send the ‘Clear down’ signal.
t
Calling back from the queue channel D
While in the standby condition, push and hold [Digital But-
q
ton] for 1 sec. to enter the queue memory channel selec-
tion mode.
Push [CH Up] or [CH Down] to select the desired record.
w
<
QUEUE
>
–QUEUE!–
TXCE CALL TXC BIFN
Push [Call] or [PTT]* to call.
e
* PTT call can be made only when PTT call capability is permit-
ted.
NOTE:
When no answer back is received, the trans-
ceiver repeats the call 3 times (default) automatically,
and
“
WAIT
” is displayed during each call. However, an
error beep sounds and
“
FAILED
”
is displayed when no
answer back is received after the calls.
Push [PTT] to transmit; release to receive.
r
Push [Moni(Audi)] to send the ‘Clear down’ signal.
t