Icom ic-f1000d series, Operating Manual

Page: 5 / 31

1
PANEL DESCRIPTION
1-3
LED indicator
The LED indicator indicates the status of various
parameters of the transceiver as follows:
(Reference: R=Red, G=Green, O=Orange)
Cloning (reading or writing data) •
G G G G G G G G
Cloning Error (if cloning fails) •
R G R G R G R G R G R G R G R G
Inh, Blank CH, Unlocked •
(when you cannot use the channel)
R O R O R O R O R O R O R O R O
TX Low Battery 2 (while transmitting) •
R R R R R R R R R R R R
TX Low Battery 1 (while transmitting) •
R R R R R R R R R R R R R R
Call LED=ON •
(when receiving a matching 2-Tone or 5-Tone)
O O
Call LED=Blink •
(when receiving a matching 2-Tone or 5-Tone)
O O
Scanning •
G G
Low Battery 2 (You must charge the battery.) •
G G G G
Low Battery 1 (You should charge the battery.) •
G G
Calling •
O O O O O O
Audible •
O O
When turning ON the power •
R O G R O G
Lockout, TX Inh, TOT •
(when transmit is inhibited)
R R R O O O
Successful •
O O O O G G G G
Failed, Error •
O O O O R R R R
Emergency, Siren •
R O G R O G R O G R O G
Transmitting •
R R R R R R R R R R R R R R R R
Receiving •
G G G G G G G G G G G G G G G G
The following LED indicator patterns are repetitive.
One cycle is approximately two seconds.
The following LED indicator patterns light only once.